Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994AEROSTAR AWD V6-245 4.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONPINPOINT TESTSDB - EGR TEMPERATURE SENSORDB7 - INDUCE OPPOSITE CODE
1994 Ford Aerostar AWD V6-245 4.0L
DB7 - Induce Opposite Code
1994 Ford Aerostar AWD V6-245 4.0LSECTION DB7 - Induce Opposite Code
- Key "OFF".
- Clear continuous memory. Clearing Diagnostic Trouble Codes
- Disconnect EGR Temperature (EGRT) sensor.
- Connect a jumper wire between EGRT circuit and SIG RTN circuit at the EGRT sensor vehicle harness connector.
- Start engine and run for at least two minutes.
- Turn engine "OFF" and rerun Key On Engine Off (KOEO) Self-Test.
- Is Continuous Memory Diagnostic Trouble Code (DTC) 327 present?
Yes -- Replace EGRT sensor. Clear continuous memory. Clearing Diagnostic Trouble Codes
Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)
No -- Remove jumper. Go to DB8. DB8 - Check Continuity of Harness Circuits
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.