SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1993PICKUP F250, 2D PICKUP, 5.0 N, STANDARD, M5OD-R2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 41 (SERVICING - A/T)ADJUSTMENTSMANUAL LEVER POSITION SENSOR (MLPS)E4OD
1993 Ford Pickup F250, 2D Pickup, 5.0 N, Standard, M5OD-R2

Manual Lever Position Sensor (MLPS): E4OD

1993 Ford Pickup F250, 2D Pickup, 5.0 N, Standard, M5OD-R2SECTION E4OD
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1994 Ford RV Cutaway, 1994 Ford Pickup, 1994 Ford F-Super Duty, 1994 Ford Econoline, and 1994 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove shift linkage from transmission. Loosen MLPS retaining screws. Using MLPS Aligner (T89T-70010-J), align manual lever position sensor for Neutral gear. See Fig 1. Tighten retaining bolts to specification. See TORQUE SPECIFICATIONS. Install shift linkage.

Fig 1: Adjusting Manual Lever Position Sensor (E4OD)
G92H22357Courtesy of FORD MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.