Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver-Side Air Bag Module: Installation
Connect air bag module wiring connector to clock-spring (contact assembly) connector. Position air bag module on steering wheel. Install air bag module nuts and washers, and tighten to specification. See TORQUE SPECIFICATIONS table at the end of this article. Activate air bag system. Check AIR BAG warning light to ensure system is functioning properly. See TESTING - SYSTEM OPERATION CHECK .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.