SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1993PICKUP F250, 2D PICKUP, 5.0 N, STANDARD, M5OD-R2REPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGA/C COMPRESSOR REFRIGERANT OIL CHECKINGCHECKING COMPRESSOR OILNIPPONDENSO 6P148 6-CYL., 10P13, 10P15C & 10P15F 10-CYL.
1993 Ford Pickup F250, 2D Pickup, 5.0 N, Standard, M5OD-R2

NIPPONDENSO 6P148 6-CYL., 10P13, 10P15C & 10P15F 10-CYL.

1993 Ford Pickup F250, 2D Pickup, 5.0 N, Standard, M5OD-R2SECTION NIPPONDENSO 6P148 6-CYL., 10P13, 10P15C & 10P15F 10-CYL.
  1. Start and operate engine at high idle with A/C on for 15 minutes. Stop engine. Slowly discharge system using approved refrigerant recovery/recycling equipment. Remove A/C compressor. Drain compressor oil. Measure amount drained, and discard oil.
  2. If amount drained is 3-5 ounces, add drained amount to compressor using NEW refrigerant oil; add oil through suction port. If amount drained is less than 3 ounces, add 3 ounces.
  3. If amount drained is more than 5 ounces, add 5 ounces. Use NEW "O" rings on refrigerant lines. Install A/C compressor. Evacuate and recharge system. Perform leak test.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.