Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Sensor Power Circuit Check
Turn ignition on. Using voltmeter, measure voltage between circuits No. 298 and 837 at steering sensor connector on Crown Victoria and Grand Marquis. Measure voltage between circuits No. 295 and 57 at steering sensor connector on Town Car. If battery voltage indicated, replace steering sensor. If no voltage indicated, repair shorted or open circuit and proceed to QUICK TEST G1 .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.