Retrieving Codes

1992 Ford Tempo LX, 2.3 X, StandardSECTION Retrieving Codes

Service codes are retrieved from EEC-IV system through self-test connector. Various methods and test equipment may be used to access these codes:

  • Analog Volt-Ohmmeter (VOM).
  • Scan tester.
  • In-Dash Malfunction Indicator Light (MIL) or CHECK ENGINE light.
SELF-TEST CONNECTOR LOCATIONS

Application Location
Continental & Mark VII Right Front Fender Apron
Cougar & Thunderbird In Front Of Right Shock Tower
Crown Victoria & Grand Marquis Left Inner Fender, Above Wheelwell
Escort 1.9L & Tracer 1.9L Right Rear Of Engine, Near Cowl
Town Car Left Firewall, On Wiper Cover
Mustang Left Shock Tower, Near Ignition Coil
Probe 3.0L Left Rear Of Engine Compartment
Sable & Taurus Right Rear Of Engine, Below Map Sensor
Tempo & Topaz Right Rear Of Engine Compartment, Near Cowl
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.