Sending Units & Sensors

1992 Ford Tempo LX, 2.3 X, StandardSECTION Sending Units & Sensors
SENDING UNITS & SENSORS LOCATION

Component Location
Air Bag System
Center Front Crash Sensor (2.3L) Forward of hood latch. See Figure .
Left Front Crash Sensor (2.3L) In left front corner of engine bay. See Figure .
Rear Crash Sensor Behind center of instrument panel.
Right Front Crash Sensor (2.3L) In right front corner of engine bay. See Figure .
Safing Sensor Behind center of instrument panel, near rear crash sensor.
Air Charge Temperature (ACT) Sensor
2.3L On air cleaner assembly. See Figure .
3.0L On air cleaner assembly. See Figure .
Cylinder Identification (CID) Sensor (2.3L) Near distributor. See Figure .
EGR Valve Position (EVP) Sensor (3.0L) On center of firewall. See Figure .
Engine Coolant Temp. (ECT) Sensor
2.3L On thermostat housing. See Figure .
3.0L On thermostat housing. See Figure .
Fuel Gauge Sending Unit On top of fuel tank.
Mass Airflow (MAF) Sensor
2.3L On air cleaner assembly. See Figure .
3.0L On air cleaner assembly. See Figure .
Pressure Feedback EGR Sensor
2.3L In engine bay, on center of firewall. See Figure .
3.0L On timing chain-end of engine, to right of right valve cover. See Figure .
Temperature Gauge Sending Unit
2.3L On thermostat housing. See Figure .
3.0L On thermostat housing. See Figure .
Throttle Position Sensor (TPS)
2.3L On throttle body assembly. See Figure .
3.0L On throttle body assembly. See Figure .
Vehicle Speed Sensor (VSS) (2.3L) On transaxle, facing firewall. See Figure .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.