Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1992TAURUS V6-182 3.0L DOHC SHOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONINTEGRATED CONTROL RELAY MODULESERVICE AND REPAIR
1992 Ford Taurus V6-182 3.0L DOHC SHO
Integrated Control Relay Module: Service and Repair
1992 Ford Taurus V6-182 3.0L DOHC SHOSECTION Service and Repair
REMOVAL
1. Remove radiator sight shield.
2. Disconnect electrical connector.
3. Remove Integrated Relay Control Module (IRCM) assembly located on radiator support.
INSTALLATION
1. Install integrated relay control module assembly on radiator support.
2. Connect electrical connector.
3. Tighten retaining nuts to 36 in lb (4 Nm).
1. Remove radiator sight shield.
2. Disconnect electrical connector.
3. Remove Integrated Relay Control Module (IRCM) assembly located on radiator support.
INSTALLATION
1. Install integrated relay control module assembly on radiator support.
2. Connect electrical connector.
3. Tighten retaining nuts to 36 in lb (4 Nm).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.