Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1992TAURUS V6-182 3.0L DOHC SHOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONPINPOINT TESTSDH - THROTTLE POSITION (TP) SENSORDH - TESTING NOTES
1992 Ford Taurus V6-182 3.0L DOHC SHO
DH - Testing Notes
1992 Ford Taurus V6-182 3.0L DOHC SHOSECTION DH - Testing Notes
NOTE: You should enter this Pinpoint Test only when you have been directed here from Quick Test.
REMEMBER
To prevent the replacement of good components, be aware that the following non-EEC areas may be at fault.
- Idle speed/throttle stop adjustment
- Binding throttle shaft/linkage or speed control linkage.
- Choke/high cam system
- TP sensor may not be seated properly
This Pinpoint Test is intended to diagnose only the following:
- Throttle Position (TP) sensor
- Sensor harness circuits: VREF, TP, and SIG RTN
- Processor assembly
DESCRIPTION
The Throttle Position (TP) sensor is a potentiometer that provides a signal to the EEC processor that is directly proportional to throttle plate position.
REMEMBER
To prevent the replacement of good components, be aware that the following non-EEC areas may be at fault.
- Idle speed/throttle stop adjustment
- Binding throttle shaft/linkage or speed control linkage.
- Choke/high cam system
- TP sensor may not be seated properly
This Pinpoint Test is intended to diagnose only the following:
- Throttle Position (TP) sensor
- Sensor harness circuits: VREF, TP, and SIG RTN
- Processor assembly
DESCRIPTION
The Throttle Position (TP) sensor is a potentiometer that provides a signal to the EEC processor that is directly proportional to throttle plate position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.