Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1992TAURUS V6-182 3.0L DOHC SHOREPAIR AND DIAGNOSISINSTRUMENT PANEL, GAUGES AND WARNING INDICATORSSPEEDOMETER CABLESERVICE AND REPAIR
1992 Ford Taurus V6-182 3.0L DOHC SHO
Speedometer Cable: Service and Repair
1992 Ford Taurus V6-182 3.0L DOHC SHOSECTION Service and Repair
REMOVAL
1. Disconnect speedometer cable (core and casing assembly) from speedometer head.
2. Pull speedometer core out of upper end of casing.
3. If core is broken, open hood and work from top side of engine compartment to remove cable from transaxle, or from speed control speed sensor, if so equipped.
4. Remove lower part of the core (if broken) from lower end of casing.
INSTALLATION
1. Install new core into casing (inserting it from speedometer end).
2. Install hex nut retaining speedometer cable to transaxle or install cable in speed sensor, if so equipped.
3. Connect speedometer cable (core and casing assembly) to speedometer head.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.