SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1992RANGER 2D PICKUP, 2.9 T, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGA/C SYSTEM GENERAL SERVICINGORIFICE TUBE REPLACEMENT - ALL OTHERREMOVAL
1992 Ford Ranger 2D Pickup, 2.9 T, Standard

Orifice Tube Replacement - All Other: Removal

1992 Ford Ranger 2D Pickup, 2.9 T, StandardSECTION Removal
  1. Orifice tube is located in condenser-to-evaporator liquid refrigerant line near condenser by the 3 indented notches or circular depression in the line. See Fig 1 .
    Fig 1: Determining Orifice Tube Location
    G90J02503Courtesy of FORD MOTOR CO.
  2. Disconnect negative battery cable. Discharge A/C system using approved refrigerant recovery/recycling equipment. To remove liquid line, fit appropriate spring lock coupling clamp on the line. See SPRING LOCK COUPLING CLAMP table earlier in article.
  3. Close clamp and push into opening side of cage to expand garter spring and release female fitting. After garter spring is expanded, pull coupling apart. See Figure . Remove liquid line.
  4. Locate orifice tube in metal portion of liquid line (3 indented notches or circular depression). See Fig 1 . Note angle positions of liquid line ends for reassembly. Cut a 2 1/2" (63.5 mm) section from tube at orifice location. DO NOT cut closer than 1" (25.4 mm) from start of bend in liquid line. See Fig 2 .
  5. Flush out liquid line. Lubricate "O" rings with refrigeration oil. Assemble orifice tube kit on liquid line. See Fig 2 . Ensure replacement orifice tube is the same color as that removed.
  6. Ensure flow direction arrow is pointed at evaporator and taper on ferrule is toward the nut. While holding hex of liquid line in a vise, tighten each compression nut to 65-70 ft. lbs. (88-95 N.m).
    Fig 2: Identifying Orifice Tube Kit Components
    G104014Courtesy of FORD MOTOR CO.
  7. Reconnect line, using a new "O" ring lubricated with refrigeration oil. Leak test, evacuate and recharge the system. Check system for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.