Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cylinder Balance Test
This test helps identify a weak or non-contributing cylinder in engines with sequential PFI fuel systems. ECA shuts off fuel supply to each injector and measures RPM drop. It computes variation between cylinders and identifies weak ones. This test mode is entered from KOER SELF-TEST after all codes have been displayed. Within 2 minutes after codes have been displayed, lightly depress throttle (a 2-3 degree throttle angle is required, not a wide open throttle). After a brief stabilizing period, ECA will activate test procedure. Test will be repeated if throttle is depressed within 2 minutes of final code output. During second and third test sequences, percentage of allowable variation between cylinders is reduced. Service codes displayed during this test identify weak or non-contributing cylinder. See CYLINDER BALANCE TEST SERVICE CODES . If Code 90 is displayed during this test, system has passed test. If Code 77 is displayed, repeat cylinder balance test. If throttle is moved during this test, Code 77 will appear, indicating test is not completed. Total test time is about 3 minutes.
| Service Code | Application |
|---|---|
| 90 | Pass |
| 10 | Cylinder No. 1 |
| 20 | Cylinder No. 2 |
| 30 | Cylinder No. 3 |
| 40 | Cylinder No. 4 |
| 50 | Cylinder No. 5 |
| 60 | Cylinder No. 6 |
| 70 | Cylinder No. 7 |
| 80 | Cylinder No. 8 |
| 77 | Retest |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.