Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1992CROWN VICTORIA TOURING, AOD-EREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC TESTINGFUEL SYSTEMINERTIA SWITCH
1992 Ford Crown Victoria Touring, AOD-E
Inertia Switch
1992 Ford Crown Victoria Touring, AOD-ESECTION Inertia Switch
- If inertia switch is tripped, engine cannot be restarted until switch is manually reset. To reset inertia switch, depress switch button. Inertia switches may be found in the following locations:
- On Sable and Taurus, in left side of trunk (except station wagon).
- On Sable and Taurus station wagon models, behind access door in right rear cargo area.
- On all other vehicles, in trunk on left hinge support or behind trim panel.CAUTION: DO NOT reset inertia switch until fuel system has been inspected for leaks.
- To test inertia switch, turn ignition off. Remove inertia switch. Shake inertia switch to force switch into tripped position (switch open).Measure resistance of switch. See INERTIA SWITCH RESISTANCE . Replace switch if resistance is incorrect, or if switch cannot be tripped.
INERTIA SWITCH RESISTANCE
| Switch Position | Ohms | ||||
|---|---|---|---|---|---|
| Open (1) | 10,000+ | ||||
| Closed (2) | 0-5 | ||||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.