Ignition Systems

1991 Ford Thunderbird LX, 5.0 TSECTION Ignition Systems
NOTE: For additional information and descriptions see IGNITION SYSTEMS in the THEORY & OPERATION article. Perform the Spark Output Check as outlined in the BASIC TESTING article before entering these tests. Some ignition systems require that Quick Test procedure be performed prior to testing. This will retrieve trouble codes from the EEC-IV system. See the TESTS W/CODES article in this section.
IGNITION SYSTEM ACRONYMS (1)

Acronym Definition
BAT+ or BAT (+) Battery Positive
BAT- or BAT (-) Battery Negative
BOB Breakout Box
CBD Closed Bowl Distributor (TFI-IV)
CCD Computer Controlled Dwell (TFI-IV)
CID Cylinder Identification
C1, C2, C3 Coil Drive (Coils 1, 2 & 3)
DIS Distributorless Ignition System
ECA Electronic Control Assembly (EEC-Processor, Computer, Processor)
EDIS Electronic Distributorless Ignition System
DPI Dual Plug Inhibit (High Signal - Right Plugs Fire) (Low Signal - Both Sides Fire)
IDM Ignition Diagnostic Monitor (Diagnostic Signal to ECA)
IGGND Ignition Ground (Low Current Ground Reference)
KOEC Key On Engine Cranking (Testing Condition
KOEO Key On Engine Off (Testing Condition)
KOER Key On Engine Running (Testing Condition)
PIP Profile Ignition Pickup (Crankshaft Sensor Signal)
PWR GND Power Ground Circuit to TFI Module
SAW Spark Angle Word
SPOUT Spark Output (ECA Spark Control Signal)
TFI or TFI-IV Thick Film Ignition (IV is 4th Generation)
VPWR or VBAT Battery Power or Battery Voltage
VRS or VR Sensor Variable Reluctance Sensor (Crankshaft)
(1) Not all circuits and components are used in all systems.
IGNITION SYSTEM IDENTIFICATION

Application System
Continental 3.8L (1)(2) TFI-IV
Cougar & Thunderbird
3.8L (1)(2) TFI-IV
5.0L (1)(2) TFI-IV
Crown Victoria & Grand Marquis 5.0L TFI-IV
Mark VII 5.0L TFI-IV
Mustang 5.0L HO TFI-IV
Probe 3.0L (2) TFI-IV
Sable & Taurus
2.5L (Taurus Only) (2) TFI-IV
3.0L (2) TFI-IV
3.8L (1)(2) TFI-IV
Tempo & Topaz 2.3L HSC TFI-IV
(1) Closed Bowl Distributor (CBD)
(2) Computer Controlled Dwell (CCD)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.