Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Quick Test B6: Check Harness Short To B+
Turn ignition to RUN position. Disconnect EVO actuator valve harness connector at power steering pump. Measure voltage across pin No. 13 (Yellow/Light Green wire) and pin No. 5 (Black wire). Measure voltage across pin No. 14 (Light Blue wire) and pin No. 5. If voltage is more than 5 volts, a short is indicated. Service wires as necessary and proceed to QUICK TEST A0 . If voltage is less than 5 volts, proceed to QUICK TEST B7.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.