Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1991RANGER 2WD L4-140 2.3L SOHCREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIR
1991 Ford Ranger 2WD L4-140 2.3L SOHC
Engine Control Module: Service and Repair
1991 Ford Ranger 2WD L4-140 2.3L SOHCSECTION Service and Repair
The processor stores data about vehicle operating conditions and uses this information to compensate for component tolerances. When an emission related component is replaced, Keep Alive Memory (KAM) should be cleared to erase the data stored by the processor from the original component.
1. With the ignition switch OFF, disconnect the negative battery cable for a minimum of five minutes, then reconnect the cable.
2. Operate the vehicle for a minimum of ten miles to allow the Engine Control Assembly (ECA) to relearn values for optimum driveability and performance.
NOTE: Distance varies with vehicle application.
1. With the ignition switch OFF, disconnect the negative battery cable for a minimum of five minutes, then reconnect the cable.
2. Operate the vehicle for a minimum of ten miles to allow the Engine Control Assembly (ECA) to relearn values for optimum driveability and performance.
NOTE: Distance varies with vehicle application.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.