Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test 39, Check Advance Spark Angle
If engine timing is greater than 15 degrees BTDC when EDIS diagnostic cable SAW DETECTOR button is released, EDIS ignition is functioning normally. Go to TROUBLE SHOOTING-NO CODES article for other possible causes of symptoms. If timing is less than 15 degrees BTDC when EDIS diagnostic cable SAW DETECTOR button is released, go to next test.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.