Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1991PROBE GL, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESINSTRUMENT PANEL - ELECTRONICTESTINGSEAT BELT WARNING LIGHT GROUND CHECK NO. 2
1991 Ford Probe GL, Standard
Seat Belt Warning Light Ground Check No. 2
1991 Ford Probe GL, StandardSECTION Seat Belt Warning Light Ground Check No. 2
- Ground Black wire at seat belt buckle switch 4-pin connector, located inside right door panel. See IDENTIFYING WARNING LIGHT CIRCUIT illustration.
- If SEAT BELT warning light comes on, repair Black wire between seat belt buckle switch and ground. If SEAT BELT warning light does not come on, replace seat belt buckle switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.