Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1991PROBE GL, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESINSTRUMENT PANEL - ELECTRONICTESTINGSEAT BELT WARNING LIGHT GROUND CHECK NO. 1
1991 Ford Probe GL, Standard
Seat Belt Warning Light Ground Check No. 1
1991 Ford Probe GL, StandardSECTION Seat Belt Warning Light Ground Check No. 1
- Ground Brown/White wire at seat belt buckle switch 4-pin connector, located inside right door panel. See IDENTIFYING WARNING LIGHT CIRCUIT illustration.
- If SEAT BELT warning light comes on, go to SEAT BELT WARNING LIGHT GROUND CHECK NO. 2. If SEAT BELT warning light does not come on, repair Black/White wire between CPU and seat belt buckle switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.