Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1991PROBE GL, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORMOTORS
1991 Ford Probe GL, Standard
Electrical Component Locator: Motors
1991 Ford Probe GL, StandardSECTION Motors
MOTORS LOCATION
| Component | Location |
|---|---|
| Blower Motor | Behind right end of instrument panel. |
| Fuel Pump/Sender Unit | In fuel tank, accessible through panel under rear seat cushion. |
| Mode (Function) Control Actuator Motor | Behind instrument panel, on left side of heater case. |
| Rear Washer Pump Motor | Behind left rear interior trim panel. |
| Recirc./Fresh Actuator Motor | Behind instrument panel, on left side of blower motor case. |
| Temperature Blend Actuator Motor | Behind instrument panel, on right side of heater case. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.