Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1991CUTAWAY 5.8 H, C6REPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGSTEERING SYSTEM - INTEGRAL POWEROVERHAULSTEERING GEAR HOUSINGREASSEMBLY
1991 Ford Cutaway 5.8 H, C6
Steering Gear Housing: Reassembly
1991 Ford Cutaway 5.8 H, C6SECTION Reassembly
- Lubricate new seals and seal bore with multi-grease. Place dust seal on Seal Installer (T77L-3576-A) so raised lip of seal faces installer. Place pressure seal on installer so lip faces away from installer. See Fig 1 .
- Insert installer into sector shaft bore. Drive in until seals just clear snap ring groove. DO NOT bottom seals against bearing, install snap ring. Apply grease to area between seal lips.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.