Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Maintenance Service Reminder Reset - Procedure 01
1991 Ford Cutaway 5.8 H, C6SECTION Maintenance Service Reminder Reset - Procedure 01
NOTE:
For models with Standard Instrument Cluster.
- The SERVICE light will come on approximately every 7500 miles, indicating routine service is required. The light will remain on for 3 minutes after vehicle is started.
- To cancel the message and reset SERVICE light on 1990 models, depress and hold SERVICE RESET button until 3 beeps are sounded. This will verify that reminder light has been reset. SERVICE RESET button is located in VMM unit, in center of overhead console.
- To cancel the message and reset SERVICE light on 1991-92 models, insert a small diameter shank into hole centered directly above VMM display lights, and press switch once.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.