Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test 44, Check For Saw Open
With key off and ECA disconnected, set DVOM to 2-k/ohm scale. Measure resistance between breakout box pin No. J45 (SAW E) and vehicle harness connector pin No. 36. See Figure. If resistance is less than 5 ohms, SAW is not being transmitted by ECA. Replace ECA. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes. If resistance is greater than 5 ohms, repair open circuit. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.