Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test 41, Check Saw For Short In EDIS Module
With key off, connect ECA. Set DVOM to 20-volt scale. Push EDIS diagnostic cable SAW button. Start engine, and measure voltage between breakout box pins No. (+) J21 (EDIS diagnostic cable SAW detector) and (-) J7 (BAT -). If voltage is 5-7 volts, SAW is shorted in EDIS module. Replace EDIS module. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes. If voltage is not 5-7 volts, go to next test.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.