Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test 32, Check For IDM Short High
Turn key off. Connect EDIS Diagnostic Cable (007-00059) to breakout box (T83L-50-EEC-IV), EDIS module and coil pack. DO NOT connect VR sensor tee. See Figure. Use EDIS No. 6 overlay. Connect EDIS diagnostic cable negative and positive leads to battery. Set EDIS diagnostic cable box switch to 4/6 CYLINDER position. Set DVOM to 20-volt scale.
Crank engine, and measure voltage between breakout box pins No. J30 (EDIS diagnostic cable IDM detector) and J7 (BAT -). If pulses are present, IDM detector output will be 5-7 volts DC. If pulses are present, go to next test. If pulses are not present, go to TEST 34.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.