Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test 24, Check VRS Circuit For Short To VBAT
With key off and ECA disconnected, disconnect EDIS module from EDIS module tee, leaving diagnostic cable connected to vehicle harness connector. Set DVOM to 20-volt scale. Turn key on, but leave engine off. Measure voltage between breakout box pins No. J48 (VRS E) and J7 (BAT -).
If voltage is greater than 0.5 volt, repair short circuit. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes. If voltage is less than 0.5 volt, replace EDIS module. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.