Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Maintenance Service Reminder Reset - Procedure 01
Every 5000 or 7500 miles, depending upon engine application, a SERVICE interval reminder light on the dash will illuminate (for approximately 30 seconds), or begin flashing, indicating an oil change is due.
To reset reminder light, turn ignition on. Simultaneously depress and hold TRIP (ODO SEL on Taurus and Sable, SYSTEM CHECK or CHECK OUT on Continental) and RESET or TRIP RESET buttons. On Probe, depress and hold SERVICE RESET button, located on speed alarm keyboard. On all models, 3 beeps will verify that reminder light has been reset.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.