Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Ford Taurus V6-232 3.8LFACTORY OEM SERVICE PROCEDURE
Front
To adjust toe-in, lock steering wheel in straight ahead position using suitable steering wheel holder. Loosen and slide off small outer clamps from steering boot to prevent boot from twisting during adjustment procedure. Loosen tie rod adjusting, then adjust left and right tie rods until each wheel has 1/2 the desired total toe specification. Tighten tie rod adjusting nuts and install clamps. Remove steering wheel holding tool.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.