Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Ford Taurus V6-232 3.8LFACTORY OEM SERVICE PROCEDURE
Cruise Control Switch: Service and Repair
1. Disarm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. Remove four air bag module retaining nuts.
3. Remove module from steering wheel, then disconnect contact assembly from module. Place air bag module on a flat surface, with the trim cover facing up.
4. Disconnect electrical connectors from switch.
5. Remove two screws and washers retaining switch to steering wheel.
6. Remove switch and wiring assembly.
7. Reverse procedure to install.
8. Reactivate airbag as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. Remove four air bag module retaining nuts.
3. Remove module from steering wheel, then disconnect contact assembly from module. Place air bag module on a flat surface, with the trim cover facing up.
4. Disconnect electrical connectors from switch.
5. Remove two screws and washers retaining switch to steering wheel.
6. Remove switch and wiring assembly.
7. Reverse procedure to install.
8. Reactivate airbag as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
