Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1988TAURUS L4-153 2.5L HSCREPAIR AND DIAGNOSISCRUISE CONTROLDESCRIPTION AND OPERATIONSYSTEM ACTIVATION
1988 Ford Taurus L4-153 2.5L HSC
System Activation
1988 Ford Taurus L4-153 2.5L HSCSECTION System Activation
To operate the speed control system, the engine must be running and the vehicle speed must be greater than 30 m.p.h.. The system is activated by pressing the ON switch on the steering wheel. Then, the operator must depress and release the SET ACCEL switch. This will result in the current speed being maintained until a new speed is set by the operator, the brake pedal is depressed, the clutch pedal is depressed or the OFF switch is depressed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.