Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Deceleration Control System: Operation
The manifold vacuum is routed through the solenoid vacuum valve to the vacuum throttle positioner (modulator). The solenoid vacuum valve is normally in the closed position.
Power is available to the solenoid vacuum valve through an electronic sensor, but the sensor ground circuit is open. When the engine speed is greater than the predetermined RPM setting, a signal is sent to the solenoid, which allows the manifold vacuum to activate the throttle positioner.
The vacuum pulls the throttle positioner diaphragm, which pushes the throttle to the high idle position, during deceleration.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.