Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1988BRONCO 4.9 Y, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCONTROL UNITS
1988 Ford Bronco 4.9 Y, Automatic
Control Units
1988 Ford Bronco 4.9 Y, AutomaticSECTION Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS Control Module | Under left center of dash. |
| Diesel Warning Light Module | Behind left side of dash, near fuse block. |
| Electronic Engine Control (EEC) Module | On left corner of firewall. |
| Glow Plug Controller (Diesel | On left rear top of engine. |
| Rear Defrost Controller | Under left side of dash. |
| Shift Control Module | On right side of cowl. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.