Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1987ECONOLINE E350, VAN DISPLAY, 4.9 YREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMFUEL INJECTION SYSTEM - MULTI-POINTTORQUE SPECIFICATIONS
1987 Ford Econoline E350, Van Display, 4.9 Y
Torque Specifications
1987 Ford Econoline E350, Van Display, 4.9 YSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Air Intake Throttle Body | ||
| 2.3L | 12-15 (16-20) | |
| 4.9L & 5.0L | 12-18 (16-24) | |
| EGR Tube-to-EGR Valve | ||
| 2.3L & 2.9L | 18-28 (24-38) | |
| 4.9L & 5.0L | 25-35 (34-47) | |
| Fuel Supply Manifold Bolts (4.9L & 5.0L) | 12-15 (16-20) | |
| Lower Intake Manifold Bolts | ||
| 2.3L | 15-22 (20-30) | |
| 2.9L | 11-15 (15-20) | |
| 3.0L | 20-28 (27-38) | |
| 4.9L & 5.0L | 23-25 (31-34) | |
| Upper Intake Manifold Bolts | ||
| 2.9L | 11-15 (15-20) | |
| All Other Engines | 15-22 (20-30) | |
| INCH Lbs. (N.m) | ||
| Air Intake Throttle Body (2.9L) | 72-96 (8-11) | |
| Fuel Pressure Regulator | ||
| 2.9L | 72-96 (8-11) | |
| All Other Engines | 26-40 (3-4.5) | |
| Fuel Supply Manifold Bolts (2.9L & 3.0L) | 72-96 (8-11) | |
| Pressure Relief Valve Cap | 4-6 (.5-.7) | |
| Thermostat Housing Bolts | 72-86 (8-11) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.