Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1987ECONOLINE E350, VAN DISPLAY EXTENDED, 6.9 1REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERSTARTER - 6.9L DIESELON-VEHICLE TESTINGSOLENOID WINDING TESTSHOLD-IN WINDING (ALL MODELS)
1987 Ford Econoline E350, Van Display Extended, 6.9 1
Hold-In Winding (All Models)
1987 Ford Econoline E350, Van Display Extended, 6.9 1SECTION Hold-In Winding (All Models)
- Connect an ammeter, voltmeter, carbon pile and battery into starter circuit. See Figure . Using carbon pile, decrease battery to 9 volts for Ford Motor Co.models.
- Ammeter should read 12-16 amps for Ford Motor Co. models. Higher reading indicates winding is shorted or grounded. Lower reading indicates excessive resistance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.