Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1987ECONOLINE E150, VAN CARGO EXTENDED, 5.0 NREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMEGR SYSTEMTESTINGEGR REMINDER LIGHT RESET PROCEDURE
1987 Ford Econoline E150, Van Cargo Extended, 5.0 N
EGR Reminder Light Reset Procedure
1987 Ford Econoline E150, Van Cargo Extended, 5.0 NSECTION EGR Reminder Light Reset Procedure
- Turn ignition off. Insert Phillips screwdriver into hole in timer unit. While lightly pushing screwdriver in, turn ignition switch to the "RUN" position.
- With EGR reminder light on, hold screwdriver in place for 5 seconds. Remove screwdriver. Reminder light should go out in 2-5 seconds. If not, repeat steps 1) and 2).
- Turn ignition off. Turn ignition switch to the "RUN" position. Reminder light should come on for 2-5 seconds and then go out. This checks proper reset of light module.
NOTE:
Reminder light is activated by an electronic module which senses engine-on time rather than actual mileage. Reminder light is designed to come on at approximately 60,000 miles.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.