Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1987ECONOLINE E150, VAN CARGO EXTENDED, 5.0 NREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERSTARTER - MOTORCRAFTOVERHAULREASSEMBLY
1987 Ford Econoline E150, Van Cargo Extended, 5.0 N
Starter - MOTORCRAFT: Overhaul: Reassembly
1987 Ford Econoline E150, Van Cargo Extended, 5.0 NSECTION Reassembly
- Position 3 coils and pole pieces and install attaching screws. As pole shoe screws are tightened, strike frame with a soft hammer to seat and align pole shoes, then stake screws.
- Install remaining coil and retainer. Bend tabs to secure coil to frame. Position new field brush lead on field coil terminal. Install clip to hold brush lead to terminal. Solder lead, clip and terminal together with a 300-watt soldering iron and rosin core solder.
- Ground coil around retaining sleeve by positioning small diameter wire leading from coil under copper tab which attaches contact to frame. Install ground brushes to frame with screws.
- Lubricate armature shaft splines with Lubriplate. Install drive gear assembly on armature shaft. Install new retaining stop ring and stop retainer.
- Install armature in frame. Partially fill drive end housing bearing bore with grease. Position drive gear plunger lever to frame and starter drive assembly and install pivot pin.
- Install plunger lever return spring and drive end housing to frame. Install brush holder, brushes and springs. Install brush holder insulator.
- Position end plate to frame and align plate locator with frame slot. Install and tighten through bolts to 55-75 INCH lbs. (6-8 N.m). DO NOT pinch brush leads when installing end plate. Position drive gear plunger lever cover on starter and tighten cover screw.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.