Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1985MUSTANG LX, 2D HATCHBACK, 5.0 FREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEIGNITION SYSTEMIGNITION SYSTEM - DURA-SPARK IITESTINGRUN CIRCUITS CHECK
1985 Ford Mustang LX, 2D Hatchback, 5.0 F
Run Circuits Check
1985 Ford Mustang LX, 2D Hatchback, 5.0 FSECTION Run Circuits Check
- Remove ignition coil wire from distributor cap and install spark tester on wire. Turn ignition switch from "OFF" to "RUN" to "OFF" several times.
- Sparks should occur at tester gap each time switch goes from "RUN" to "OFF" position. Remove spark tester and reconnect coil wire to distributor cap.
- If sparks occurred in step 1, check distributor cap, adapter and rotor for cracks, carbon tracking or lack of silicone compound. Also check for roll pin retaining reluctor to sleeve in distributor shaft and check that Orange and Purple wires are not crossed between distributor and control module.
- If no sparks occurred in step 1, proceed to Control Module Voltage Check.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.