One Mirror Does Not Function

1985 Ford Econoline E250, Van Window Extended, 4.9 Y, C6SECTION One Mirror Does Not Function
  1. Working underneath mirror, remove head of plastic rivet, using a 1/4" (6 mm) drill. Remove rivet stem remnants. Remove screw from cover, remove cover, and disconnect plug. Check function of mirror by connecting 12 volts to terminals of wire plug.
  2. Yellow and Green wires provide up-down movement; Blue and White wires, right-left movement. If mirror does not function, replace motor drive. See MIRROR GLASS & MOTOR DRIVEΒ  under REMOVAL & INSTALLATION.
  3. If mirror functions when tested, but does not operate when connected to feed wire, remove left door panel. Test feed wire for continuity between switch plug and mirror plug. Repair or replace wiring, if necessary. If mirror functions through feed wire, but fails to respond to switch operation, replace switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.