Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1985E 350 VAN V8-6.9L DSLREPAIR AND DIAGNOSISMAINTENANCESERVICE INTERVALSNORMAL SERVICE60000 MI OR 96000 KM
1985 Ford E 350 Van V8-6.9L DSL
60000 MI or 96000 KM
1985 Ford E 350 Van V8-6.9L DSLSECTION 60000 MI or 96000 KM
Lubricate
Wheel Hub (Locking)
Universal Joint, Drive/Propeller Shaft
Throttle Cable/Linkage
Steering and Suspension
Shift Linkage, A/T
Clutch Linkage
Brake Caliper
Lubricate caliper slide rails.
Clean
Fuel/Water Separator
Check
Brakes and Traction Control
Tighten/Torque
Wheels
Inspect
Power Steering Fluid
Intake Air Duct
Drive Belt
Disc Brake System
Clutch Fluid
Brake Fluid
Replace
Oil Filter, Engine
Fuel Filter
Fluid - Transfer Case
Engine Oil
Coolant
Air Filter Element
Clean/Repack
Wheel Bearing
Wheel Hub (Locking)
Universal Joint, Drive/Propeller Shaft
Throttle Cable/Linkage
Steering and Suspension
Shift Linkage, A/T
Clutch Linkage
Brake Caliper
Lubricate caliper slide rails.
Clean
Fuel/Water Separator
Check
Brakes and Traction Control
Tighten/Torque
Wheels
Inspect
Power Steering Fluid
Intake Air Duct
Drive Belt
Disc Brake System
Clutch Fluid
Brake Fluid
Replace
Oil Filter, Engine
Fuel Filter
Fluid - Transfer Case
Engine Oil
Coolant
Air Filter Element
Clean/Repack
Wheel Bearing
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.