Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1985BRONCO 5.8 G, STANDARD, TODREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 38 (3.0L EFI EEC IV TESTING)
1985 Ford Bronco 5.8 G, Standard, TOD
Section 38 (3.0L EFI EEC IV Testing)
1985 Ford Bronco 5.8 G, Standard, TODSECTION Section 38 (3.0L EFI EEC IV Testing)
WARNING: This page is about a different car, the 1986 Ford Aerostar. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnosis & Testing
- Quick Tests
- Circuit Tests
- Notes
- Test A - No Start
- Test B - Vehicle Battery
- Test C - Reference Voltage
- Test D - Act Sensor
- Test F - Coolant Temperature Sensor
- Test G - Manifold Absolute Pressure/Barometric Pressure (Map/BP) Sensor
- Test H - Knock Sensor
- Test I - Throttle Position Sensor (TPS)
- Test M - Neutral A/C Switch Input
- Test N - Key Power Check
- Test O - Brake On/Off (Boo) Switch
- Test P - PSPS (Power Steering Pressure Switch)
- Test S - Fuel Control
- Test T - Inertia Switch
- Test U - EGR On/Off Check
- Test W - Canister Purge (CANP) Check
- Test X - Idle Speed Control (By-Pass Air)
- Test Cc - Wot-A/C Cut-Out (Wide Open Throttle A/C Cut-Out (WAC) A/C Demand
- Test Dd - Converter Clutch Override (CCO)
- Test Ee - Dynamic Response Test
- Test Ff - Ignition Diagnostic Monitor (IDM)
- Test GG - Spark Timing Check
- Test HH - No Codes/Codes Not Listed
- Test II - System Check
- Test JJ - Erratic Ignition
- Test KK - Inlet Air Solenoid (IAS)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.