SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1985BRONCO 5.8 G, STANDARD, TODREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 35 (2.3L EFI EEC IV TESTING)SELF-DIAGNOSTICSPREPARATION FOR TESTING
1985 Ford Bronco 5.8 G, Standard, TOD

Preparation For Testing

1985 Ford Bronco 5.8 G, Standard, TODSECTION Preparation For Testing
WARNING: This page is about a different car, the 1986 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Correct test results for system are dependent on the correct operation of several related non-EEC components and systems. All non EEC problems should be corrected before attempting to diagnose the EEC system.

Before hooking up any equipment to diagnose the EEC system, make the following checks:

  • Verify condition of air cleaner and air ducting.
  • Check all vacuum hoses for leaks, restrictions, and proper routing.
  • Check the EEC-IV system wiring harness electrical connections for corrosion, loose or detached connectors, loose wires or terminals, and proper routing.
  • Check the ECA, sensors and actuators for physical damage.
  • Perform all necessary safety precautions to prevent personal injury or vehicle damage.
  • Set parking brake and place shift lever in "P" for auto. trans., and Neutral for man. trans. DO NOT  move shift lever during testing unless specifically directed to do so.
  • Turn off all lights and accessories, and make sure that vehicle doors are closed when making readings.
  • Check and correct coolant level.
  • Start engine and idle until upper radiator hose is hot and pressurized and throttle is off fast idle. Check for leaks around exhaust manifold, exhaust gas oxygen sensor, and vacuum hose connections.
  • Turn ignition key off. Service items as required, then go to EQUIPMENT HOOK-UP  .

NOTE: If engine will not start, starts but stalls, idles rough or runs rough, go through KEY ON/ENGINE OFF (KOEO) SELF-TEST  . If any of the above conditions are still present after a code 11 in the KEY ON/ENGINE OFF (KOEO) SELF-TEST  , go to CIRCUIT TEST  A, step 2) for a no start condition. If engine stalls or runs rough, go to DIAGNOSIS BY SYMPTOM TEST  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.