TFI Ignition Module

1985 Ford Bronco 5.8 G, Standard, TODSECTION TFI Ignition Module
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 1984 Ford Ranger, 1984 Ford RV Cutaway, 1984 Ford Pickup, 1984 Ford Econoline, and 1984 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

The TFI module triggers ignition coil and determines dwell. Module is mounted on side of distributor. ECA uses signal from Profile Ignition Pick-Up to determine crankshaft position. Ignition timing is determined within ECA. ECA then signals TFI module when to fire coil.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.