Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1985BRONCO 5.8 G, STANDARD, TODREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (SERVICING - M/T)LUBRICATIONSERVICE INTERVALSSHIFT LINKAGE
1985 Ford Bronco 5.8 G, Standard, TOD
Shift Linkage
1985 Ford Bronco 5.8 G, Standard, TODSECTION Shift Linkage
WARNING: This page is about a different car, the 1985 Dodge Ramcharger, 1985 Dodge Ram Wagon, 1985 Dodge Ram Van, 1985 Dodge Pickup, and 1985 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Gearshift control mechanism should be lubricated every 2 years or 22,500 miles. Lubricate if shift effort or noise is apparent. The 4-speed gearshift linkage has a grease fitting located on left side of mechanism.
- Use a high pressure grease gun to lubricate linkage with multipurpose grease, until grease is visible on operating levers.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.