Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1985BRONCO 5.8 G, STANDARD, TODREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONMAINTENANCE REMINDER LIGHT (RESET PROCEDURES)MAINTENANCE SERVICE REMINDER (VMM)MAINTENANCE SERVICE REMINDER RESET - PROCEDURE 03
1985 Ford Bronco 5.8 G, Standard, TOD
Maintenance Service Reminder Reset - Procedure 03
1985 Ford Bronco 5.8 G, Standard, TODSECTION Maintenance Service Reminder Reset - Procedure 03
- Turn ignition switch to ON position. Within 16 seconds of turning ignition on, insert small diameter shank into reset switch hole, and firmly push in switch. Reset switch hole is located on left side of VMM panel.
- Keep switch depressed until left side of display stops flashing. If switch is not kept depressed until left side of display stops flashing, VMM will not be reset.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.