Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1984RV CUTAWAY 5.8 GREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETUNE-UPIGNITION SYSTEM - DURA-SPARK IITESTINGCONTROL MODULE TO DISTRIBUTOR WIRING HARNESS CHECK
1984 Ford RV Cutaway 5.8 G
Control Module To Distributor Wiring Harness Check
1984 Ford RV Cutaway 5.8 GSECTION Control Module To Distributor Wiring Harness Check
- Disconnect 4-wire control module connector. Connect an ohmmeter lead to distributor base. Alternately, connect the other ohmmeter lead to wiring harness connector terminals that mate with Orange and Purple wires of control module connector.
- If resistance is greater than 70,000 ohms, test result is OK. Proceed to "Ignition Coil Secondary Resistance Check". If resistance was less than 70,000 ohms, check wiring harness between control module connector and distributor, including distributor grommet.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.