Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
American Motors & General Motors
Turn wheels to full left position and add power steering fluid to cold mark on dipstick. Start engine and run at fast idle, check fluid level and add as necessary to cold mark on dipstick. Bleed system by turning wheel from side to side without hitting stops. Maintain fluid level just above pump housing. Fluid with air in it will have a light tan or red appearance. All air must be eliminated before normal steering action can be obtained. Return wheels to center position and operate engine for another 2-3 minutes. Road test vehicle and recheck fluid level. Level must be at hot mark on dipstick after fluid is at normal operating temperature.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.