Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Compressor Oil Check: Notes
Oil level on Air-Temp, Tecumseh, and York compressors may be checked with compressor mounted in vehicle. If these compressors are equipped with stem-type service valves, compressor may be "isolated", thereby avoiding necessity of discharging entire system (see COMPRESSOR ISOLATING or related paragraphs). General Motors (6 Cylinder) compressors may have to be removed from vehicle for oil check, as filler plug is located near the bottom of the compressor (refer to appropriate method for procedures). After oil level is checked and adjusted, A/C system must be evacuated and recharged before it can be put back into service.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.