Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD1969FALCON BASE, 5.8L ENG VIN H, NOT AVAILABLE TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATERS - MANUAL SYSTEMSMUSTANG & COUGARAIR DOOR CONTROL CABLE

1969 Ford Falcon Base, 5.8L Eng VIN H, Not Available Trans

Air Door Control Cable

1969 Ford Falcon Base, 5.8L Eng VIN H, Not Available TransSECTION Air Door Control Cable

Loosen cable retaining clip at front of heater plenum, move control upper lever to heat position detent. Position air door crank arm between two dots on plenum chamber and tighten cable retaining clips.

Fig 1: Heater Controls - Montego

Courtesy of FORD MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.