Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1997VISION V6-201 3.3L VIN T SFIREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULEDESCRIPTION AND OPERATIONWIPER SYSTEM
1997 Eagle Vision V6-201 3.3L VIN T SFI
Wiper System
1997 Eagle Vision V6-201 3.3L VIN T SFISECTION Wiper System
The wiper system provides the driver with normal wipe (low and high speeds), intermittent wiper, wipe after wash, and pulse wipe functions. The driver selects the wiper function via a resistive multiplexed stalk switch mounted on the steering column. This value is then received by the BCM, which then determines the wiper motor output speed and frequency.
Pulse Wipe - When the wiper is in the off position and the driver presses the wash button for more than 62 msec but less than 1/2 second, 1 wipe cycle in low speed mode will be provided.
Wipe After Wash Mode - When the driver presses the wash button for over 1/2 second and then releases it, the wiper will continue to run for 2 additional wipe cycles.
Pulse Wipe - When the wiper is in the off position and the driver presses the wash button for more than 62 msec but less than 1/2 second, 1 wipe cycle in low speed mode will be provided.
Wipe After Wash Mode - When the driver presses the wash button for over 1/2 second and then releases it, the wiper will continue to run for 2 additional wipe cycles.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.