Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1997VISION V6-201 3.3L VIN T SFIREPAIR AND DIAGNOSISLIGHTING AND HORNSCENTER MOUNTED BRAKE LAMPSERVICE AND REPAIRLH/CP
1997 Eagle Vision V6-201 3.3L VIN T SFI
LH/CP
1997 Eagle Vision V6-201 3.3L VIN T SFISECTION LH/CP
REMOVAL
1. Release trunk latch and open trunk.
2. From under rear deck panel, disengage CHMSL wire connector from body harness.
3. Remove rear deck upper panel.
4. Remove screws holding CHMSL to rear deck upper panel.
INSTALLATION
1. Place CHMSL in position on rear deck upper panel.
2. Install screws to hold CHMSL to rear deck upper panel.
3. Install rear deck upper panel.
4. Engage CHMSL wire connector to body harness.
5. Verify CHMSL operation.
1. Release trunk latch and open trunk.
2. From under rear deck panel, disengage CHMSL wire connector from body harness.
3. Remove rear deck upper panel.
Center High Mounted Stop Lamp (CHSMSL):
4. Remove screws holding CHMSL to rear deck upper panel.
INSTALLATION
1. Place CHMSL in position on rear deck upper panel.
2. Install screws to hold CHMSL to rear deck upper panel.
3. Install rear deck upper panel.
4. Engage CHMSL wire connector to body harness.
5. Verify CHMSL operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.